Thanks to a brilliant development tapping into the infinite potential of carbon, the new creation is a case with exceptional characteristics, a completely new deep black dial and a movement needing no lubrication, guaranteed for 50 years.
The structure of carbotech enhances both the appearance and the performance of the material, which is used to make the case and the bridge device with its locking lever protecting the winding crown, thus helping to ensure the watch’s water-resistance to 10 bar (a depth of about 100 metres). To form the sheets of carbotech from which these components are made, very thin sheets of carbon fibre are pressed together at a controlled temperature under very high pressure with the organic polymer PEEK (Polyether Ether Ketone), which links the composite material, making it yet more resistant and reliable. The carbon fibres used are very long, so as to achieve great aesthetic uniformity.
The sheets are superimposed and pressed together in such a way the orientation of the fibres of each layer is out of phase with the one below or above it. This structure has the effect of increasing the mechanical properties of carbotech compared to those of similar materials or others often used in high quality watchmaking, such as ceramics or titanium. Carbotech is actually lighter and more resistant to external stresses, as well as being hypoallergenic and not subject to corrosion.
Because it is not possible to print or stamp a dial with these characteristics, all the figures are formed directly on the dial crystal, to which a double anti-reflective treatment has been applied.
The new PANERAI LAB-ID™ has a P.3001/C handwound calibre with a power reserve of three days, now presented for the very first time in an extraordinarily innovative version, semi-skeletonised, completely without additional lubrication and with only four jewels. By using a wide range of solutions, specially devised for the individual parts of the movement and associated with the unique properties of carbon, the plates, bridges, barrels, escapement and anti-shock device use self-lubricating and dry lubricating materials, and are hence exempt from any liquid lubrication. These solutions have revolutionised the need for maintaining and overhauling the calibre, enabling Panerai to guarantee it for no less than 50 years.
- To remove the need for further lubricating the main bridges and the plate, these components are made of a completely new material: a low friction composite which integrates a Tantalum based ceramic. This new generation of composite is notable for its high percentage of carbon which minimises pivot friction, making jewels and their related lubrication unnecessary.
- Also eliminated is the need to lubricate the escapement, as a result of making the main components from silicon and applying a special coating of DLC (Diamond Like Carbon) to the wheelwork.
- A good two years of testing by the Laboratorio di Idee in the Panerai Manufacture identified the best type of coating based on carbon – with which to treat the components of the two spring barrels of the P.3001 calibre, so as to make conventional lubrication superfluous. The solution was to use a series of layers and sub-layers of coating, the surface one being coated with DLC.
- Last but not least, a surface coating of DLC on the four jewels means that there is no need to further lubricate the Incabloc® anti-shock device.
Hand-wound mechanical, P.3001/C calibre, executed entirely by Panerai
Power reserve: 72H
Hours, Minutes, small seconds, power reserve indicator on the back, seconds reset
49 mm, carbotech
Water-resistance: 10 bar (~100 metres).
Deep black with luminous Arabic numerals and hour markers
Small seconds at 9 o’clock